Razor-Sharp Edges Every Time: Eliminate jagged, messy, and stringing lines. Our bedliner wire edge tape (or knifeless tape) is a specialized, flexible adhesive tape with an embedded high-tensile wire filament that slices through thick coatings from the bottom up, delivering a crisp, professional border that looks factory-installed every time.
Strong Bonding Adhesive: Specially formulated to bond instantly to scuffed paint, primers, and plastics. It stays locked in place even under high-pressure sprayers, effectively eliminating "bleed-through" on wheel flares and rocker panels. The 1/4-inch width is designed to conform to irregular shapes, tight angles, and body contours.
Versatile 100 Foot Roll: With 100 feet of 1/4" tape, you have more than enough length to handle full-size truck beds, wheel flares, rocker panels, and custom off-road bumpers in a single roll. A standard 6.5-foot truck bed usually requires about 30 to 40 feet for the rails and tailgate. Beyond bedliners, it doubles as a knifeless tape for precise trimming of car wraps, vinyl graphics, and protective films.
Heat and Chemical Resistant: Built to handle the heat of rapid-cure urethanes. It is fully compatible with Custom Coat, Raptor and all professional-grade spray-on or roll-on polyurethane coatings.
Installation Tip: Apply the wire tape to a clean, de-greased surface. Lay your masking paper over the non-wire half of the tape. After spraying, wait until the liner is tack-free but not fully hardened, then pull the wire at a 45-degree angle away from the liner to make a surgical cut. This will save you time on clean-up and prevent damage to your fresh coating.
