Overview

A paste putty that levels like a pourable putty. Contains Hattonite™ for improved sandability. Cures quickly to a sandable state which makes it the ideal product for quick spot filling. Stain resistant for use under basecoat & clearcoat repairs. May be applied to galvanized metal, aluminum, bare steel, body filler, two-part primers and sanded OEM finishes. Part of the MetalWorks® System. Blue cream hardener included.

FEATURES & BENEFITS:

• Cream-like consistency for improved spreading with no sag.
• Lightweight; cuts faster when sanded.
• Contains Hattonite™, an ingredient which lubricates sandpaper, reducing heat and friction for easier sanding.
• Fast drying formula ideally suited for quick spot repair.
• METALWORKS® product with ZNX-7™ to provide excellent adhesion and featheredging to galvanized steel and aluminum.
• Offers a corrosion warranty that honors the OEM warranty.

USES: Use as a finish coat over body filler repair areas to fill minor defects, deep sand scratches and pinholes prior to applying primer surfacer to improve the efficiency of the primer coat. Can also be used to fill minor body damage up to 1/8 in depth.

APPROVED SUBSTRATES: Steel, Galvanized and other zinc coated steel, and most rigid to semi-rigid fiberglass and thermo- set plastics. For flexible plastics, use POLY-FLEX™ Flexible Polyester Glazing Putty.

PREPARATION: Clean surface. Remove all dirt, oil grease and wax. Use an 80180 grit disc to remove or scuff paint. Surface must be completely dry before application.

MIXING: Place desired amount of putty on a clean, non-fibrous mixing board. Add a ribbon of cream hardener from edge to edge across the center of dispensed putty. Puddles larger than 4 in diameter will require additional hardener. Mix thoroughly until uniform color is achieved. Approximate setting time is 5-6 minutes @ 75 to 80F (27C).

APPLICATION: Spread a thin layer of mixed material over surface using firm pressure to ensure best adhesion. Apply additional layers building area slightly higher than the surface to allow for sanding. Do not apply over fresh or uncured coatings.

FINISH: Sandable in approximately 20 minutes. Sand hardened putty with 180-220 grit sandpaper followed by 320 grit if desired.